3D Printers Compared

Affiliate disclosure: some links on this site may later earn us a commission at no cost to you. We have not been approved by any affiliate program yet, so every link is a plain link right now. Details.

3D print first layer not sticking? Fixes from Bambu's wiki

Last checked Nov 18, 2026 · How we check

Bambu's wiki lists three common causes: the wrong plate type selected in the slicer, a plate that hasn't been washed, and stale bed-leveling data. For textured PEI plates it recommends warm water and detergent, not alcohol.

The facts, with sources

ItemWhat we foundSource
Bambu: first layer not stickingCheck plate type in the slicer, wash the plate, re-run bed leveling
What the source says
1. Incorrect plate type selected ... 2. Plate has not been washed before starting a print ... We strongly recommend to wash the plates with hot water and detergent before printing ... 3. Bed leveling calibration has not been performed
wiki.bambulab.com, checked Nov 18, 2026
Bambu: cleaning a textured PEI plateWarm water and detergent, not alcohol
What the source says
The reason why we recommend detergent for cleaning the textured plate is due to its textured surface. Alcohol might just spread the oils on the print surface instead of removing it.
wiki.bambulab.com, checked Nov 18, 2026

Quick checklist

  1. Pick the plate you're actually using in the slicer so the bed temperature is right.
  2. Wash the plate with hot water and dish detergent; don't touch the print area.
  3. Run bed leveling before the print.

More guides and comparisons

Report a wrong or outdated fact